Converters, Testers and Adaptors

Check Tester

This check tester has 18 LEDs to check EIA interface problem by plugging the CHECK tester between custom equipment. The LEDs light up red for positive, green for negative and both light together for proper data transfer of EIA lines 2,3,4,5,8,11,19 and 20.
Connectors : DB25P male and DB25S female on each end.

RS-232 Mini Tester

This RS-232 mini tester is easy to test for failed RS-232 interfaces. 7 two-color LED's monitor the most commonly used RS-232 lines : 2(TD), 3(RD), 4(RTS), 5(CTS), 6(DSR), 8(CD) and 20(DTR). It requires no external power and is powered directly from the RS-232 port.
Connectors : DB25P male and DB25S female on each end

Break Out Box

RS-232C
Power source : signal
Display signal status
3-state (Two-color LED)
Multimedia extender

Mini Gender Changer

9MM, 9MF, 9FF
15MM, 15MF, 15FF
25MM, 25MF, 25FF
37MM, 37MF, 37FF

Gender Changer

DB9 MM, MF, FF
DB15 MM, MF, FF
DB25 MM, MF, FF
DB9/DB25 MM, MF, FF, FM
MD6M/DB9 MM, MF, FF, FM
DIN5/MD6 MM, MF, FF, FM

Sun Monitor to VGA Adaptor

HD 15 female to 13W3P male adaptor

PS/2 to AT keyboard adaptor

DIN 5P female to mini DIN 6P male

Serial Mouse to PS/2 adaptor

Mini DIN 6P male to DB9P male

The IC-485S is a hardware solution to the problem of converting signals between two standards. Data transfer can be accomplished at up to 1200m (4000ft) and can utilize either 4-wire or 2-wire cable for full or half duplex respectively. The converter copes with any RS-485/422 device to function as a short haul modem or an interface converter.
Request to Send (RTS) selection enables up to 32 receivers to be set up in a multi-drop connection, thus making a cost effective network. Point-to-point and monitor connections are also possible.

Convert from parallel to serial or serial to parallel with the SXP-320 or the SXP-325. For an added advantage, the SXP-325 contains 256KB of memory, giving the additional benefit of a printer buffer to the unit. Both units contain a DIP switch for easy data flow direction setting. Small enough to make it portable for convenient operation almost anywhere. The units support hardware handshake and XON-XOFF software handshake, and have a serial speed of up to 38400 bps with a maximum parallel transfer rate of 10K Bytes per second.

This compact unit plugs directly into the back of your asynchronous terminal, which saves the space that a standalone unit would use and also eliminates the bulk and cost of RS-232 cables. Your line driver is powered by the host RS-232 interface and therefore requires no separate outlet or power supply. It provides 1500VAC lightning surge protection and differential circuitry. The unit is switch selectable for DCE/DTE.

The Line Driver provides asynchronous transmission and operates full-duplex over 4 wires. At slower speeds, the distance increases. Transmission performance may vary depending on operating conditions and wire gauge.