NEUTRA™ solid surface is an exciting new product created for a lifetime
of easy care. It requires minimal care, even on dark colours which are
more prone to show cuts and smudges. NEUTRA™ solid surface is also
resistant to stains, heat, moisture, impact and fading caused by exposure
to sunlight. Ordinary and stubborn stains are wiped away, even scratches
and cuts are easily removed.
Routine Care
NEUTRA™ solid surface comes in 3 types of finishes, i.e. satin, semi-gloss and high gloss finish. NEUTRA ™ sinks come in only satin finish.
Normal Cleaning
Soapy water will remove most dirt and stains from the 3 types of finishes.
Stubborn
Stains
On satin finish,
use an abrasive cleanser and green Scotch-Brite* pad.
On semi-gloss
finish, use a white Scotch-Brite pad and slowly remove the stain.
On high gloss finish, use only non-abrasive cleansers with a soft sponge or cloth to remove stains. Finish it off with a white polishing compound.
* Registered trademark of the 3M Company.
Preventing Damage
- Avoid cutting on the surface. The use of a cutting board is recommended.
- Hot cookwave can damage the surface. The use of a trivet or other insulating pad is recommended.
- Some products such as acid or alkaline cleansers can mar or permanently discolour the surface if allowed to remain for an extended period.
- Accidental spills or splatter from harsh materials should be wiped off immediately and then rinsed with water. Some examples of these items are toilet bowl cleaners, rust removers and contact adhesive solvents.
Heat
NEUTRA™
solid surface is highly heat resistant. However, frying pans and heat
generated appliances may damage the suraface if placed directly onto it.
Always use a hot pad or trivet equipped with rubber feet to protect the
NEUTRA™ surface from these appliances. It is advisable to run cold
water when pouring boiling water into NEUTRA™ solid surface sink.
Cuts & Scratches
On satin finish, scratches and cuts can be sanded away starting with 120 grit medium sandpaper and following with 180 or 220 grit fine sandpaper until the cut is gone. To restore the finish, use an abrasive cleanser and a green Scotch-Brite pad.
On semi-gloss finish, same procedures as on satin, but use a non-abrasive cleanser with a white Scotch-Brite pad.
On high gloss finish, minor scratches and stubborn stains can be buffed away using white polishing compound and a low speed** polisher equipped with a wool pad. Finish with a counter top wax.
** 1500-2000 rpm
NEUTRA™ solid surfaces are completely renewable. Should the above damages occur, please contact your NEUTRA™ agent.
| Home | About Us | Products | Applications | Use & Care |
Updated
on April '2000
Feedback : neutra@singnet.com.sg
